I resolve with moving the chip, on donor pcb, It was my reader that couldn't read that chip, but moving it made it work great.

HITACHI HDT721010SLA360 P/N 0A38016 S/N MH2PEA5K MLC BA3013 I have this patient arrived with a burned pcb, I tried several times to read the rom separately but the external reader I have tells me "empty chip", I have not yet tried to solder the rom on a donor pcb, but if the chip was empty...

Unfortunately even with the heating method and air cool spray nothing changes at all, I think that the state of the nand is really bad, so the customer will have to settle for a partial recovery.

I have this intenso SM2259 I loaded the loader and built the translator, but when reading it gives me many ECC errors and it is very very slow, they advised me to heat the nand chips up to 160°, but I was wondering, do the chips have to be heated constantly for the whole reading phase, or do I have ...

excatly, Last week, I had a case of a customer with glued heads, and from the label it was identical to another customer who had good heads but firmware problems, I go to unglue the heads, but I don't turn on the patient, I directly insert the donor heads, the donor turns on, reads modules, sectors,...

Terrible records, scratch easily, sometimes same record, same preamp, not compatible or other times clean surface, you plug in a donor head, after 20 minutes it breaks, totally useless.

But now smartphones have double hardware and software encryption, so it is unthinkable to perform the chip-off technique, many customers who contact us ask for a recovery on deleted data, but it is almost impossible, so where will the data recovery on smartphones go?

I need a soldering iron with a very thin tip to connect the wires of the microsd and sd with the pads, in addition to the well-tested JBC I found this, opinions? Has anyone ever used it? Advice for other valid and not too expensive models? https://quick-global.eu/product/quick-ts1200-digital-solderi...

We had the mobile, it had a few models, many of which were Chinese phones, last year they offered me the money I spent to get it back, because they said they would only update up to a certain point, because the mobile pro had come out which we couldn't buy.

So the spiderboard can be good for monolithic ones that have large pads but for everything else it is much more useful to solder, will they improve it? or will they get rid of it?